Mounting Bracket and Wire for a Optronics Clearance Light # AL90AS
Question:
What bracket and wire do I need for the Optronics Light AL90AS? Amber marker.
asked by: Lai
Expert Reply:
For a mounting bracket you will need the Optronics Bracket for A91 Series Lights # A91OB. This bracket is confirmed by Optronics to fit on the back of your AL90AS light. This bracket comes with a gasket which creates a weather-tight seal.
For a wire, I recommend the Right Angle 2-Wire Pigtail for Optronics Lights # A49PB. This Wire is convenient as the right angle allows the wires to run down from the light instead of straight out the back. The red wire splices right into your trailer and I recommend using the Deka Heat Shrink Butt Connectors # DW05744-5 when installing your clearance light. If you are not concerned about having a right angle, the 2-wire Pigtail for Optronics Lights # A46PB will also work with your clearance light and will not take up as much space behind the light.
Products Referenced in This Question
Right Angle 2-Wire Pigtail for Optronics Trailer Lights - 2-Prong PL-10 Plug - 6" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 6 Inch Long
- Two Wire
- Right Angle Pigtail
- Optronics
more information >
Right Angle 2-Wire Pigtail for Optronics Backup and Utility Trailer Lights - 2-Prong PL-3 Plug
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Two Wire
- Right Angle Pigtail
- Optronics
more information >
Deka Heat Shrink Butt Connector - 16-14 Gauge - Nylon Insulation - Blue - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 16-14 Gauge
- Deka
more information >
Product Page this Question was Asked From
Mounting Bracket for Optronics A91, AL82, AL90, AL91, and AL191 Series Lights - Open Back - Chrome
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Chrome
- Optronics
more information >
Continue Researching
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Can I Use Both the 7-Way and 4-Way Connectors at the Same Time on a 2015 Chevrolet Silverado
- Q&A: Hitch Extension for Towing a Boat on a Truck with an In-Bed Truck Camper
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Reese Extension/Reducer # RP45292 Compatibility with Class V Factory Hitch on 2013 Ram 2500
- Q&A: Taillight Replacement for Trailer with SAE Number 1ST P2-84-DOT
- Article: Trailer Wiring Diagrams
- Q&A: Closest Metric Replacement Tire Size for 7.00-15 Tire on Livestock Trailer
- Article: Trailer Lighting Requirements
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Boat Trailer Showdown: Bunks vs. Rollers