Tie Down Anchor Recommendation for Trailer That Has 3/4 inch Depth Restriction

Question

Question:

I have an installation question. With my particular installation, the depth of the hole is limited to a depth of only 3/4inch deep. Will the Brophy RR5K be able to fully recess into a hole that is only 3/4inch deep? Thanks.

asked by: Blain O

1

Helpful Expert Reply:

I have a solution for you, but the part # RR5K would stick down too far for the hole you have that only can fit 3/4 inches of depth. For a similar rated tie down anchor that surface mounts instead you would want the part # LRB1 which has a 4k capacity.

I attached an install video for you to check out as well.

expert reply by: Jameson C

1

Answer 1

You could mount a spare tire carrier on the frame of your trailer or along the inside of metal railing of your trailer. I would recommend using a spare tire carrier that mounts to the frame of the trailer, like the item you selected, Fulton Hi-Mount…

view full answer...

Answer 2

Usually the actual part numbers for a trailer light will be found on the light's base or on its rear surface. The DOT codes you found on the lens are not part numbers, but since you took measurements of the lens we can check for a replacement red…

view full answer...

Answer 3

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 6

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 7

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 8

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 9

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 10

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 11

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 12

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Tie Down Anchor Recommendation for Trailer That Has 3/4 inch Depth Restriction

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching