How Does Brake Controller Install Harness for a 2013 Toyota Tacoma Ground
Question:
I have a 2013 Toyota Tacoma with factory-installed tow package. I have ordered the Tekonsha Prodigy P2 controller and located the vehicles plug near the emergency brake. Where/how do I connect the ground wire to the truck frame? I found what look like studs near the vehicle brakes, can I just loosen one of those screws and install the ground there? I cannot tell how you do it from the picture you provide on the product page of your website at 3040-P I am mechanically challenged, I had hoped all I had to do was plug things in. Thanks!
asked by: Ann M
Expert Reply:
The reason you have to also run a separate ground on the # 3040-P to install the P2 part # 90885 is because the ground of the harness just isn't quite sufficient enough for powering the brake controller.
If you watch the install video I attached that shows this harness installing a brake controller in a similar 2012 Tacoma you can see exactly how we grounded this harness. All you need to do is use a self tapping screw with a drill and run the ring terminal to the sheet metal right near where you found the harness.
For that you would need the part # FA1131822 for screw (may as well get a few). I know it seems like a difficult process but if you take your time it's not too hard. You will just need a drill and a socket for the bolt head. You will put the ring terminal on the screw's threads and then drill it to a sheet metal section of the vehicle.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Toyota and Lexus
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Self-Tapping Screw - 1/4" -14 x 3/4" Long - Zinc
- Accessories and Parts
- Trailer Wiring
- Wiring
- Ground Screw
- Flint Hill Goods
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)