Trailer License Plate Holder with Light for a Haulmark Trailer

Question

Question:

Do you have a lighted version of LP35BB? I had a Haulmark Trailer with the same plate holder but it contained a light. I want to relocate a hanging plate from below the rear bumper on my 5th Wheel Toy Haulerto the rear door. Id like a flush, lighted holder.

asked by: Dave P

0

Expert Reply:

We have license plate mounting brackets that have lights but there isn't a version of # LP35BB that has a light. We have # LPL55CB which has an LED light or # LP55CB with an incandescent bulb.

expert reply by: Michael H

0

Answer 1

I did some research on your 2009 Haulmark Low Hauler trailer. I was able to see several different styles of license plate lights and holders on trailers. I have attached a link to our product page for license plate lights. Some have the license plate…

view full answer...

Answer 2

If you already have a breakaway switch and trying to find its power source, It is possible that someone could have wired the breakaway switch directly to the main battery on the trailer but it does not come like that from the factory. The breakaway…

view full answer...

Answer 3

The 125255UC seal has a 1.249" ID and a 1.983" OD and for that our part #34823 will be the correct replacement.

view full answer...

Answer 4

Most pintle hooks use a standard bolt pattern which is 3-3/8" horizontally center to center and 1-3/4" vertically center to center (see photo). Therefore, the Pintle Hook part #C48231 would be a direct fit and work well for you. It also…

view full answer...

Answer 5

Yes, the Demco Spare Tire Carrier part #DM15851-76 does work great with the tire size ST235/80R16 that you referenced. We had a customer with your exact tire size send us a picture of it carrying the wheel which I attached.

view full answer...

Answer 6

The locking storage box #M387FR mounts in the floor. As long as you have the 19" wide x 29" long x 7-1/4" deep space, it can absolutely work in a toyhauler. The box recesses into the floor and is powder coated for protection against…

view full answer...

Answer 7

The Trailer License Plate Holder with LED Light #328-003-71BE uses non-submersible lights. Although this would not work well on your boat trailer, I have a different solution. I recommend using the LED Trailer License Plate Light #LPL82CBB. This…

view full answer...

Answer 8

The generally accepted rule for psi increases with temperature is that for every 10 degree change there is a 2% change in psi. For tire pressures like yours like #WE76FR that require 110 psi that ends up being 2 psi for every 10 degrees of…

view full answer...

Answer 9

You always need to keep your trailer tires filled to the max cold psi rating. If your current load range G tires have a 110 psi rating then that is what you need to keep them filled to. Tire blowouts are a result of damaging a tire (like hitting…

view full answer...

Answer 10

The method you described would be a great way to determine what length to cut the #H20046. That way you would end up with enough wire that it wouldn't come unplugged when making a tight turn. Securing the wire up and out of the way is a smart…

view full answer...

Answer 11

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Trailer License Plate Holder with Light for a Haulmark Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching