Trailer Hitch and Wiring for a 2015 Volvo V60 R Design
Question:
Would the rear diffuser on this car need to be altered to mount this receiver? If so, what is the extent of the alteration?
asked by: Randy B
Expert Reply:
Curt trailer hitch # C12066 is listed as a fit for all models of the 2015 Volvo V60 including the R Design models. There is some trimming required on that center fascia section. I have included a picture that shows where the trimming needs to be.
If you want to use the hitch for an accessory such as a bike rack or cargo carrier then you have to make sure the accessory is rated for use with a Class II trailer hitch. Curt also says you have to use stabilization strap # 18050 when using this hitch for any non-trailer load (such as a bike rack or car go carrier) per their warranty requirements.
If you plan on doing some towing the correct ball mount to use is # C45521. For a 1-7/8 inch ball use # 19256 and for a 2 inch ball use # 19258. For trailer wiring use # C56287 (mid-year models and newer).
Products Referenced in This Question
Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1
- Accessories and Parts
- Hitch Bike Racks
- Hitch Cargo Carrier
- Tie Down Straps
- CURT
more information >
1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- CURT
more information >
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Shop: Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1
- Video: Trailer Hitch Installation - 2014 Volvo S60
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Will the Wiring Harness # C59496 Fit on a 2006 Volvo XC70
- Q&A: Can Trailer Hitch Extender hes0 Be Used for Towing with a 2007 Ford Explorer
- Q&A: Locating Factory Weldnuts on 2003 Volvo V70 to Install Curt Trailer Hitch # C12318
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Hitch Receiver Sizes
- Q&A: Location of Fascia Triming for Installation of CURT Class II Part # C12066 on 2010 Volvo V70
- Article: How Much Trailer Can I Really Tow
- Q&A: Recommended Brake Controller for Different Trailers and Tow Vehicles
- Q&A: Is Fascia Trimming Required to Install Hitch on 2017 Volvo V60
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Hitch Installation Tips
- Article: How to Install a Trailer Hitch