Brake Controller Port Location 2013 Lexus LX 570
Question:
Even Lexus dealer could not find to port, should have been just inside the dash behind the remote mirror switches, where is it?
asked by: Phil
Expert Reply:
The port you will want to plug your brake controller wiring adapter # 3040-P into will be located under the dash on the left side, behind the fuel and hood latch levers. The brake controller plug will need to be removed from its port, and connected with the wiring harness. I have attached some pictures from a customer in regards to the location of the brake controller port in your 2013 Lexus LX 570.
If you cannot find the harness, and the dealership technicians cannot find the harness, it may be that your vehicle does not have the brake controller harness. In that case, you would need to use the universal pigtail, # 20127 and a brake controller wiring kit # 5506 to hardwire the brake controller to the vehicle.
Products Referenced in This Question
Replacement Brake Control Plug-In Harness for Tekonsha and Draw-Tite Brake Controller 12" Long
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Universal
- Draw-Tite
more information >
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Toyota and Lexus
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Brake Controller
- Search Results: blue tooth brake controller
- Search Results: 90195
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Shop: Trailer Wiring
- Search Results: bump stops
- Shop: SumoSprings Solo Custom Helper Springs - Rear Axle
- Shop: Suspension Enhancement
- Shop: Autowbrake Electric Brake Controller - Trailer Mount w/ Remote Fob - 1 to 3 Axles - Proportional
- Q&A: Brake Controller Install Port Location on a Toyota Land Cruiser
- Shop: Hopkins Plug-In Simple Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Flat Connectors
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Search Results: 68149
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Video: Choosing the Right Brake Controller
- Search Results: 25580
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Search Results: dust cap
- Shop: Fifth Wheel Hitch
- Article: Brake Controller Installation: Starting from Scratch