Recessed D-Ring Tie Down Recommendation for a Trailer

Question

Question:

Shopping for recessed trailer D-Ring tie downs. Anything in stock with between rating of the RR05 5000 lb max load, 1600 lb WLL, and RR01C 1200 lb max load, and 400 lb WLL? RR05 is too heavy for my needs, yet RR01C is too light for my needs?

asked by: Bill

0

Expert Reply:

The D-Ring part # RR06 has a 2,000 lb capacity. That is the only recessed mounted D-ring we carry that has a capacity between the # RR01C and the # RR05.

I would recommend you go with more capacity that you need as opposed to less than you need.

expert reply by: Jameson C

0

Answer 1

As long at you have the appropriate size bolts and hardware for the D-Ring Tie Down Anchor #RR06 you will not need the backing plate. The backing plate #BP06 wouldn't offer your D-ring anymore support than the steel frame itself would, but it…

view full answer...

Answer 2

The Brophy Swiveling D-Ring Tie Down Anchor #RR06 would work great in a car hauler application like yours. Each of these has capacity of 2,000 lbs working load limit and 6,000 lbs break strength so with a few of these securing a vehicle you'd…

view full answer...

Answer 3

Since you are planning on installing these Trailer D-Rings #RR06 in a plywood floor I would recommend you also get the Backing Plate #BP06 to offer better support than just the wood of your trailer floor. As far as the placement of them in your…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Recessed D-Ring Tie Down Recommendation for a Trailer

Products Referenced in This Question

Continue Researching