Trailer Hitch Recommendation for a 2014 Ford Escape
Question:
I would like to know if your package kit includes a wrench for the two ball mounts that I will order in the near future. My vehicle is a Ford Escape 2014 Titanium series FWD.
asked by: Jeorge
Expert Reply:
The etrailer.com Ball Mount Kit part # 989900 does not include a wrench to tighten the hitch ball down. For a wrench to go with this kit you would want the part # C20001.
For a trailer hitch the part # 75758 that you referenced would be the correct hitch to use. I attached an install video for you to check out as well.
For trailer wiring you would want the part # 118566.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- 1-7/8 Inch Ball
- 2 Inch Ball
- Two Balls
- Steel Ball
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Drop - 4 Inch
- Rise - 1 Inch
- Rise - 3 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- Ball Mount Kit
- etrailer
more information >
Curt 6-Point Hex Wrench for Trailer Hitch Balls with 3/4" or 1" Diameter Shanks
- Accessories and Parts
- Drop Hitch
- Trailer Hitch Ball
- Trailer Hitch Ball Mount
- Tools
- Hex Wrench
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Max-E-Loader Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Q&A: How to Activate Trailer Lights on 2014 Jeep Grand Cherokee Laredo with C55515 Wiring Harness
- Q&A: Recommended Leaf Springs for Vintage Trailer
- Q&A: Replacement Leaf Springs for a Vintage Camper
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Solution for Needing Replacement Atwood Master Cylinder for Surge Actuator
- Q&A: How to Change Battery Mode on Progressive Dynamics 9300 Series RV Converter Charger
- Article: Tips on How To Tow a Trailer
- Article: Routing the Power Wire for a Trailer Wiring Harness