Yes, the Tekonsha BRAKE-EVN Trailer Brake Controller item # TK63VR will work with your 2019 Nissan Armada. Since you have the factory tow package you can use the Plug in Wiring Adapter item # 3050-P to have a plug and play installation. view full answer...
I do have a set of rear airbags for you but the Air Lift AirLift 1000 Air Helper Springs for Coil Springs part # AL60817 are not a confirmed fit for your 2017 Nissan Armada.
For a set of rear airbags that are confirmed to fit your vehicle I recommending the Firestone Coil-Rite Air Helper Springs part # F4150. I went out to warehouse and measured these airbags for you and they measure 11-1/2" tall x 4-1/3" wide. As long as you have the factory rear coil springs installed on your vehicle... view full answer...
Since you have a 2017 Armada the pre-wiring is on the right side of the steering column, above the accelerator (see pic). This is where you'll plug the part # 3050-P into for the Prodigy P3 part # 90195.
If you currently do not have any trailer wiring you'd need to hardwire in a 4-way first with the part # C59496 but your vehicle SHOULD have a 7-way already.
From there you would need to convert the 4-way to a 7-way so that you can install the brake controller. For that you will want... view full answer...
If your 2017 Nissan Aramada is the same as the Infinity QX80 as you referenced, then the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Nissan and Infiniti # 3050-P will connect to the brake control wiring harness underneath the dash to the left of the steering column. It is taped to another harness near the emergency brake pedal.
This harness will allow you to easily install your Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional, # 90195 view full answer...
The most popular 2-inch Class III hitch for your 2012 Armada is the Curt # 13188; this is also the most cost-effective hitch offered. Along with this hitch (or your existing one if you already have one) you can use the Hopkins Custom Fit Vehicle Wiring for the 2012 Armada by Nissan, part # N40975 that you referenced. This includes the relays required to activate the tow package wiring.
I have linked you to an installation video for this kit in an Armada. view full answer...
On the Black Bracket with 2-Wire Plug for MC65 Series Clearance Lights # A68PB, I've attached a video to assist in showing you ground and power. If you have the light facing you with the wires to the left, the top wire will be power and the bottom will be your ground. view full answer...
The Firestone Coil-Rite Air Helper Springs # F4150 will work with your OEM air suspension on your 2018 Nissan Armada as long as the air bags are not installed in the coil springs.
The air bag kit has a load-leveling capacity of at least 500 pounds (at most 1,000 pounds). It has an adjustable air pressure of 5 psi to 35 psi.
The air bags are made of a durable , elastic polyurethane.
I attached an installation video link below. view full answer...
If the tongue weight of your setup is 708 lbs when the trailer is fully loaded then the Fastway e2 Weight Distribution w/ 2-Point Sway Control part # FA94-00-1061 is a great choice. The Fastway e2 is designed for tongue weights between 600 lbs - 1,000 lbs so if your tongue weight when empty is 708 lbs and closer to the 1,000 lb range when loaded with cargo and weight behind the rear axle of the towed vehicle then this system may be underrated for you.
If 708 lbs is your loaded tongue weight... view full answer...
There is not a slip-on or bolt-on towing mirror for your Armada, but you can use the CIPA # 7070-2 Universal Towing Mirrors which will give you a greatly improved field of vision. You could also use the CIPA # 11953-2 model that you referred to if you like the exta convex spotter mirror. I prefer to have a larger regular mirro offered on the # 7070-2. I use these on my Chevy Colorado pickup when towing a 25' travel trailer and they make a big difference when passing and backing up.
The... view full answer...
You can add a 4-way trailer connector to your 2008 Nissan Armada, but there is not a piece that runs from from the back of the vehicle to under the dashboard, what you would need to do is hardwire in a 4-way with the following part:
- Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector # C59236
This will splice into your Armada's tail lights, and I have added a link below to the installation instructions for you to check out. view full answer...
If you installed the 60 inch Yakima Jetstream roof rack part numbers # Y00426 and # Y33TR on your 2019 Nissan Armada you would have room for your current Yakima bike rack as well as a paddleboard carrier like the Yakima SUPDawg part # Y04075. view full answer...
We have towing mirrors for your 2019 Nissan Armada, but slip-on mirrors will not fit because they are generally only made for the more popular trucks. So instead what you will need are universal fit mirrors from CIPA:
- CIPA Universal Towing Mirrors # 7070-2
The CIPA Towing Mirrors # 7070-2 have a mirror face which is large at 7-1/2" long x 5" tall to give you an optimal rear view so you can see more of what is behind you to increase your safety. They are also very easy to install, with... view full answer...
To see all of the tan, carpeted floor mats available for your 2013 Nissan Armada check out the link I provided.
Hopkins makes a semi-Custom Floor Mat in Beige that would work for you. It is part number # HM79002. This comes with mats for the front and second row. You can also get these in gray with part # HM79001, or black with part # HM79000. view full answer...
The Curt front hitch # C31081 will not fit a 2019 Infiniti QX80. The # C31081 is only for Nissan Armada 2017-2020. Unfortunately we do not offer a front hitch that will fit a 2019 QX80 at this time. view full answer...
In order to select the weight distribution system that is best for your 2008 Nissan Armada towing your 2007 Kodiak Trailer, I recommend that you start off by determining the tongue weight of your trailer when it is fully loaded. I have attached an article which is helpful in this process.
The Pro Series Weight Distribution System, # PS49582, is designed for use with trailers having a tongue weight of 550 to 750 pounds. For the best performance, you will want to choose a system where your... view full answer...
To install a trailer brake controller like the excellent prodigy P2 # 90885 in your 2008 Nissan Armada that does not have the factory tow package you will use a quick-connect harness # 3050-P. This plugs in between the controller and the port under your dash as shown in the linked video.
You'll also need 7-way and Relay Kit # N40975 which includes the trailer socket and the three relays that activate your wiring harness. An install video is linked for you. view full answer...
As long as you have a 2 inch x 2 inch receiver hitch on your Armada, the Los Angeles Chargers NFL hitch cover, item # FTHS040S, will work with your vehicle. I also recommend using a hitch lock like item # e98882.
The factory hitches included on an Armada, are typically 2 inch hitches. view full answer...
We can for sure point you in the right direction to get your 2017 Nissan Armada a roof rack so you can use your rooftop tent. What you want are bars long enough to handle your tent and also with a high weight capacity, and the best option for this is from Thule. The rack that fits your '17 Armada with raised side rails is the following:
- Thule WingBar Evo Crossbars # TH711520
- Evo Raised Rail Feet # TH710401
This rack uses 60 inch crossbars, the longest for your Armada, and both the... view full answer...
The CIPA Custom Towing Mirrors # CM11500 that you are asking about are not confirmed to fit on your 2005 Nissan Armada by CIPA themselves. Their (and my) recommendation is to use a universal towing mirror like the CIPA universal fit towing mirrors # CM11952-2. These clip onto the back of your factory mirror. That way you do not need to worry about it obstructing the view of your mirrors. I attached a video review of it below. view full answer...
Go To Results