Expert Answers about Keystone Cougar Half-Ton Travel Trailer
- Lippert Power Stabilizer Jack Not Working Properly
- Your Lippert # LC298707 Electric Stabilizer Jack is also known as the "PSX1" jack. There are a few possible issues at hand and with a bit of testing we can probably narrow in on the malfunction. First I have attached a wiring schematic for this system. Note that there should be an inline fuse between the battery and the switch. Verify that the fuse is not blown using an electrical tester like the Performance Tools # PT89ZR.
If you have power there, then trace the power to the extend/retract...
view full answer... - Bearing Kit for 2018 Keystone Cougar Half Ton 22RBS
- We do have the exact bearings, races, and grease seal you need for your 4,400 lb Dexter axle, and while there isn't a single kit with the parts, you can get them all individually. What you will need are the following:
- Bearings # L68149 and # LM67048
- Grease Seals # RG06-050
view full answer... - Width Of The MORryde Sliding Tray For RV Cargo Compartments # MR38FR
- The actual tray width is 1/4" less than sizes listed. This allows the tray to fit inside the door opening. E.g. a 20" wide tray will fit inside a 20" wide door opening, thus the MORryde Sliding Tray for RV Cargo Compartment # MR38FR is 36" wide total. The tray of these slides have a lip that goes the width of the brackets so you will need to have a 36" opening for this to work.
Since you have a 34.5" opening you would instead need to use the MORryde Sliding Tray for RV Cargo Compartment...
view full answer... - Recommended Heavier Duty Upgrade For FIC 3500 Electric A-Frame Trailer Jack
- Electric A-frame trailer jacks often have the same bolt pattern, yes. Just keep in mind that a higher-capacity jack doesn't necessarily mean more speed, it's all about the jack itself. For example, the 3,500 lb Ultra-Fab Electric A-Frame Jack # UF38-944017 extends 6" in 25.3 seconds (with 1,000 lbs of tongue weight), while the 4,000 lb Bulldog Trailer Jack # BD500200 extends 6" in 28.5 seconds (with 1,000 lbs of tongue weight).
That said, since you mentioned wanting a heavier-duty jack,...
view full answer... - Bike Rack Recommendation for e-Bikes at Back of Travel Trailer
- There definitely is a way to transport your e-Bikes on the back of your Keystone Cougar but if you're wanting to use that pull out storage rack then you'll basically just have to strap the bikes down with ratchet straps and/or bungee cords as there aren't any add-on cradles that I'm aware of.
If your Cougar has a hitch installed then the best option is the Lets Go Aero V-Lectric FAT PRO Bike Rack for 2 Electric Bikes # LGA77FR which can handle 75 lb bikes with up to a 50" wheelbase (center...
view full answer... - Recommended Blue Ox SwayPro Weight Distribution System for Travel Trailer With 640 lb Tongue Weight
- The Blue Ox # BXW1000 SwayPro is designed for trailers with tongue weights ranging from 750-1000 lbs. If the fully loaded and ready to pull trailer tongue weight of your travel trailer is less than 750 lbs, you'll have a pretty rough ride and the system won't be as effective as it should be. I'll link to an article that shows how to determine the actual as-towed tongue weight of your camper.
If the as-towed trailer tongue weight IS 640 lbs (as opposed to the dry tongue weight) then you'll...
view full answer... - Replacement Brake Assemblies For a 2022 Keystone Cougar 22MLS Travel Trailer
- With your 2022 Keystone Cougar 22MLS having a 4,400lb axles and brakes you will want to use either the Dexter 4,400LB Brakes # K23-478-479 or Lippert 4,400LB Brakes # LC66WD depending on who manufactured the axles under your Cougar.
The Dexter 3,500LB Brakes # 23-468-469 you found while being able to be installed are not constructed as durable as the higher capacity components. This means the stopping power and longevity will not be as good as with the higher capacity units. Our fit guide...
view full answer... - Attaching Solera Awning Plain Idler Head Front Cover
- To attach the Solera Awning Plain Idler Head Front Cover # LC289566 to the Solera Awning Plain Idler Head Back Cover # LC289567 you will need to use your original hardware. The two covers will fit together and you can simply screw them in using the hardware you have of the cover you are replacing.
view full answer... - Correct Bearings and Hubs for Keystone Cougar Half Ton RBS22
- The LM67048 and 25580 bearing combo is used on 5,200 - 6,000 lb trailer axles. Therefore, you do indeed have 5,200 - 6,000 lb trailer axles as opposed to 3,500 lbs. If you're looking for new hubs we have the Dexter Trailer Hub and Drum Assembly part # K08-201-98 which uses the bearings above.
view full answer... - Comparing Dometic 310 Toilets 302310093 and 302310081
- The biggest difference between the Dometic 310 part 302310093 you've currently got and the Dometic Part-Timer # DOM57FR is that the Part-Timer comes with an all wood, slow-close seat where your existing model is the retail model that comes with the plastic seat. The other difference is the color, since the # DOM57FR is white where your old toilet is considered a "bone" color. There is a slightly different color available of the 310 Part-Timer with the Dometic Part-Timer RV Toilet - Standard...
view full answer... - Replacement Water Pump Option For a 2020 Keystone Cougar 22RBS
- Unfortunately having your RV information does not tell me what fresh water pump that you have or if the HydroMax RV Fresh Water Pump # P25201 would be the correct replacement.
However, I can tell you that the HydroMax RV Fresh Water Pump # P25201 is a direct replacement for a 3-gallon-per-minute, 12-volt pump and uses 1/2" diameter hose. This pump will almost certainly work as a replacement, but whether it is a direct replacement depends on what you currently have.
If you can send me...
view full answer... - Can You Bypass Solera Exterior Smart Awning Touch Pad
- If I were you and I was having trouble with water damaging the exterior touch pad, I would first take some silicone sealant like part # LT37467 and seal up the arms as best you can at any place water could enter. If this did not work then the only option we'd really be able to offer is a new set of arms, without the exterior controller such as the Solera 12V Electric RV Awning Conversion Kit part # LC434723 for black or part # LC434724 for white. These arms would use your existing fabric...
view full answer... - Picking Out Center Cap for Wheel of 2023 Keystone Cougar 25RDS
- Hey Gary, so to pick out a wheel center cap we need to know the diameter of your wheel's pilot hole (center hole). With that we'd be able to figure out what you need. For example, the part # 319EZ is correct fit if the diameter is 3.19 inches.
I attached a link to all of the wheel center caps we offer as well if that's not correct size.
view full answer... - Correct Length Shackles and Wet Bolts For A Lippert Road Armor Shock Absorbing Equalizer
- To determine the correct length shackle straps it is best to compare your current equalizer to the Road Armor Shock Absorbing Equalizer # LC696740 that you installed on your 2021 Keystone Cougar 22MLS. A basic Equalizer # AP233 that comes on your size camper is generally 2" tall.
The Road Armor is 3-1/2" from the mounting bolt to the center line of the shackle mounting bolts. This is why you see their Kit # LC52SV having the 3-1/8" shackle straps that will keep the spring and axle height...
view full answer... - Does the Curt TruTrack Use Adjustment Head Spacers?
- The Curt TruTrack Weight Distribution System # C17501 includes 2 adjustment rods and 2 flat washers for said adjustment rods.
If you are looking for a system that is easier to set up, I suggest the Blue Ox SwayPro Weight Distribution # BXW1500. This will not use adjustment rods or washers, but will have less adjustability than the # C17501.
view full answer... - Ladder Roller that Can Fit Rola Haul Your Might Ladder Rack
- The Yakima Ladder Roller part # Y01163 would work on your Rola Haul Your Might Ladder rack. The channels on your rack are the correct dimensions for what this roller kit was designed to fit.
view full answer... - Will etrailer Cargo Carrier Clear Spare Tire When Used on 2019 Keystone Cougar Travel Trailer
- Yes, the etrailer Cargo Carrier # e98874 will absolutely have enough clearance to use and clear the spare tire on your 2019 Keystone Cougar 34TSB Travel Trailer.
Based on my research, this trailer has a hitch which is mounted and protrudes from its bumper; additionally, the trailer uses ST225/75R15 tires, so your spare will be just under 9 inches wide, which the carrier will easily clear. The SportRack Cargo Carrier measures 19-1/2 inches from the hitch pin hole to the closest edge of...
view full answer... - Recommended Replacement Ladder Options for Keystone Cougar Half-Ton
- We have some great replacement ladder options for a Keystone Cougar Half-Ton like the Stromberg Carlson Exterior RV Ladder part # LA-401BA which is 99-1/2" tall and has a 250 lb weight capacity. That said, this is a universal ladder so there may be some slight modifications needed in order to be made compatible.
Please note, we don't have any way to look up part numbers so if you're just looking for an exact bolt-on replacement you'd have to get in contact with the dealer.
view full answer... - Correct Bearings and Grease Seals for Dexter Axle # 8437302 on Keystone Cougar
- The correct grease seals and bearings for the Dexter 8437302 is as follows:
Inner bearing # L68149
Outer bearing # LM67048
Grease seal # RG06-050
For replacement hub we have the # 8-407-5UC3-EZ which includes all of the above components so you do not need to purchase them separately.
view full answer... - Can the Jacks on a 2019 Keystone Cougar 34TSB Be Converted To Ground Control Auto Level
- In order to add the auto leveling feature to your 2019 Keystone Cougar 34TSB you would need to purchase the Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System part # LC672136 which is an entire system that comes with jacks, control module, wiring, and hardware.
The reason you cannot convert what you have to the Electric Ground Control TT is because the jacks you have are not correct for the kit. The jacks you have on your trailer are actually not jacks at all but...
view full answer...
Go To Results