To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Perfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar sold separately.
Features:
Specs:
At etrailer.com we're committed to the products we sell, and to our customers. Our experienced and knowledgeable staff are available via both phone and email to address your questions and concerns for the lifetime of your hitch. The technicians at etrailer perform hitch installations on a daily basis, making them a valuable resource for do-it-yourselfers. The one-on-one, personal service you'll receive comes straight from an expert in the towing and automotive field. We've installed it, we've wired it and we've towed with it, so whatever your question, we can answer it.
Average Customer Rating: 4.6 out of 5 stars (10 Customer Reviews)
Perfect for light-duty towing, this custom, vehicle trailer hitch receiver features fully welded, gloss powder coated steel construction. Drawbar sold separately.
A very high quality product, looks great and had no blemishes. The instructions were clear and precise, and install was relatively straight forward (only a small trim modification was needed). Perfectly placed to be accessible but still pretty low profile. Works great for my bike rack.
Install was super easy. Removing exhaust does make it significantly easier and using cheap drill to enlarge the hole so you can run fishing wire was no problem. Unfortunately, its not level. Looks so goofy.
Its not the rack. Used this rack on a different car with etrailer purchased receiver without this gross tilt.
This was my second installation of a Curt product. Well built with easy directions. That said,
I have a few installation recommendations:
1. There is no need to remove the plastic panel as indicated in step one of the PDF. The hitch will fit perfectly without removal.
2. Best to completely remove the rear exhaust for easier access. Spray the rubber hangers and metal shafts with WD40. Using channel locks, grab the metal tip and the edge of the rubber hanger. It will pop right off.
3. You will indeed need to enlarge the center hole to accommodate carriage bolt and spacer.
4. There will be no need to bend the heat shield as indicated in step 4 of the PDF.
Project finished in a little over 2 hours.
Worked perfectly for my move across country with my Mazda 3 towing a small trailer!
Fits very well on my 2023 3 hatch. The instructions say you have to drill the frame, but you can remove the rear bumper instead.
Fits well on 2020 Mazda3 hatchback. Easier to install if you remove rear exhaust entirely (won’t need to drill holes larger this way as the instructions state).
Great product overall! Delivery was quick, installation directions were accurate. I did opt to take the rear exhaust off as there are only two bolts and it made working under the vehicle allot easier for drilling the factory hole bigger to accommodate the installation hardware.
Do you have a question about this Trailer Hitch?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.