bing tracking image

2006 Dodge Dakota Custom Fit Vehicle Wiring Installation And Review Videos

     

Trailer Wiring Harness Installation - 2006 Dodge Dakota- Video

Trailer Wiring Harness Installation - 2006 Dodge Dakota

Today on this 2006 Dodge Dakota we are going to install Curt wiring harness part number 55323. The wiring harness that we are going to be installing plugs in directly behind the taillights on both the driver and passenger sides of the vehicle. So, the first thing we are going to do for our installation is go ahead and remove both of the taillights. To do that, we need to go ahead and the tailgate down. If you look on the inboard side, you can see that there are two screws that are holding the taillight in place. And again that is the same on both the driver and passenger sides of the vehicle. So I am going to start my installation off over here on the passenger side of the vehicle. Go ahead and remove the two full length screws. And with the two outboard side screws removed, there are two push fasteners on the inside of the lights. So, you want to be careful when removing it. Gently rock it back and forth until you get those to release. 0:50 more


Watch Video

3/7/2011 8:33:08 AM



Trailer Wiring Harness Installation - 2006 Dodge Dakota 55323- Video

Trailer Wiring Harness Installation - 2006 Dodge Dakota 55323

Today on this 2006 Dodge Dakota, we are going to install part number 55323 from Curt. The wire harness does plug in behind the taillights. So, the first thing that we need to do is go ahead and remove the taillights. We are going to start on the driver side and work our way over to the passenger side. We are going to remove these two screws on the side right here. Looking at the light here, the top section is the part we need to disconnect two little tabs on each side here and here. Push those tabs in and the connector comes apart. Now we can start installing the T-connector. We are going to use the yellow end. That will be for the left hand side. So let us go ahead and just plug that back together. And they are also keyed, so make sure they go in the right way. And you just push them back together until they make a clicking noise. And these fit in between the wire harness in the vehicle and the taillight. 1:02 more


Watch Video

1/6/2011 2:39:49 PM



  1