2010 Chevrolet Equinox Custom Fit Vehicle Wiring Installation And Review Videos

Best 2010 Chevrolet Equinox Trailer Wiring Options- Video

Today on our 2010 Chevrolet Equinox we're going to be taking a look at the best wiring options available. The two wiring options we're going to be taking a look at are the CURT T-Connedctor, and that's part number 56094. The second one is going to be the Tekonsha T-One Connector. That's part number 118494. Both are going to provide you with a four-pole flat connector for your trailer wiring at the rear of the vehicle. The main differences between the wiring harnesses are the Tekonsha here uses a power module. What this does is it connects directly to your battery, copies the signal to your trailer wiring, and prevents overloading your car's electrical system. more

1/19/2017 10:58:54 AM

Trailer Wiring Harness Installation - 2010 Chevrolet Equinox- Video

Today on this 2010 Chevrolet Equinox we are going to install part number 56094 from Curt. This is their T-connector wiring kit. The first step involved, open up the rear hatch and we are going to have to get to the rear tail lights. Right now we are looking at the driver side tail light and what is going to happen is we are going to take off these two covers here and these have fasteners behind it to disconnect the tail lights. We are going to do this on both sides of the vehicle. Be careful when you pop these off, they can be kind of fragile. These will just pull off. Now to disconnect our tail light we are going to disconnect its junction point right here. Push down on this tab right here and it should come right apart. Now we are going to go over to the passenger side and do the exact same thing. 00:50 more

7/7/2010 7:08:39 AM

Trailer Wiring Harness Installation - 2010 Chevrolet Equinox 118494- Video

Today on this 2010 Chevrolet Equinox we are going to be installing Cequent wiring harness part number 118494. We are going to start off at the rear of the Equinox and locate the ports that the wiring harness is going to plug into. These ports are located directly behind the tail light assemblies on both the driver and passenger side. The first thing we need to do is remove both the driver and passenger side tail lights. To do that you can see we have got two covered connectors on the inboard side. We just want to pry off the lid and that is going to reveal a Phillips head screw. With those two removed we can gently rock the tail light back and forth to release the outboard clips of the tail light. With the tail light removed you can see our connection port is located directly on the back side of the tail light. We just want to depress the button on the connector and that is going to allow us to separate the two pieces. For the time being we just set the tail light off to the side. 00:53 more

3/18/2010 9:52:00 PM