Superwinch Electric Winch Wiring Installation - 2008 Ford F-350- Video
Today on our 2008 Ford F350 Super Duty we're going to be taking a look at and installing the Super Winch Trailer and Vehicle Electric Winch Wiring Kit, for up to a 16,500 pound winch, part number SW2008. Take off our rubber dust cover, plug in our winch. Let's go ahead and show you how to install it. We've used the same universal bracket 18136, available on our website. We're going to mount our plug onto that. We'll take a 7/16 wrench and we can tighten those down. You want to make sure you don't want to tighten these too tight, again they're plastic, the plug, and it can break. more
3/8/2016 2:46:34 PM
Superwinch Front Mount Electric Winch Wiring Installation - 2008 Ford F-350- Video
Today on our 2008 Ford F350 Super Duty, we're going to be taking a look at installing the Superwinch front vehicle electric wench wiring harness, part number SW2007. Now when you're ready to use your front winch take off your dust cover, we'll plug it in, and we're ready to go. When you've finished your winching job simply unplug it, place your dust cover back over it and you remover your wench. We've gone ahead and marked one of them positive, one of negative, so we can easily orient them on top, and then we get to the battery. We went ahead and made a bracket available on our website, it's universal mounting bracket, part number 18136. We're going to mount our plug to that, and then run the wires up to our battery. First we're going to go ahead and push it through. Put a couple of 3/8" bolts through there, and some locking nuts. more
3/8/2016 2:46:06 PM
Trailer Brake Controller Installation - 2008 Ford F-350 Cab and Chassis- Video
Today on our 2008 Ford F350 Chassis Cab, we'll be installing the Tekonsha Prodigy P2 Brake Controller, part number 90885, along with part number 3034-P, along with our Hopkins adapter 4 pole to 7 and 4 pole, part number 37185 mounted to the universal mounting bracket, part number 18136. Our first step, we'll be starting at the rear of the vehicle, attaching the mounting bracket. We'll be doing a custom install on this particular application. So we'll go ahead and take the mounting bracket and set it on the vehicle. Then we can take a paint marker, mark out the area around where we can attach the bracket to the vehicle and at this particular location it is the cross member. Then we'll go ahead and remove the bracket and pre-drill the holes into the cross member. Next, I'll go ahead and take a pair of vice grips and secure the bracket over the holes that we just drilled out. Now we'll be able to go ahead and pre-drill all the way through the bracket. Now that we finished our pre-drilled hole on the driver's side, we'll go ahead and repeat the same process on the passenger's side. more
11/18/2014 10:11:02 AM
