2013 Ford F-150 Accessories and Parts Installation And Review Videos

Demco Hijacker UMS 5th Wheel Underbed Rail Kit Installation - 2013 Ford F-150- Video

Shane: Hey everyone. Shane here with etrailer.com. Today I have a 2013 Ford F-150 and I'm going to walk through how to install the Demco 13,000 pound Autoslide Underbed Rail Kit. Before we get into the features of this setup, let's talk about some of the different setups you can put on your truck. Now this is the five and a half foot bed, so that leaves us two options. We can put a slider in or we put a rotating turret on the trailer. more

1/7/2021 11:27:19 AM

Best 2013 Ford F-150 Brake Controller Options- Video

Today we're going to be taking a look at the best brake controllers available for the 2013 Ford F-150. Now, all the brake controllers that we're going to look at today are proportional controllers. It's a newer technology available, and it really is just a lot better than what the time-delayed systems used to be.Basically, with the time-delayed system, it was pre-programmed when your brakes would engage. So you hit the brake in your vehicle, there might be a pause before the brakes on your trailer actually engage. With the proportional controller, we don't have to worry about that. If we hit our brakes on our truck, our brakes are going to start being applied, and they're going to be applied in proportion to how we're braking in our truck. more

7/11/2018 3:22:34 PM

Trailer Brake Controller Installation - 2013 Ford F-150 22292- Video

Rate your transcript OrderClientKevin BrossRef #20461Order #TC0761711308 Today on our 2013 Ford F-150 SuperCrew Cab, we're going to be installing the Tekonsha Prodigy P2 trailer brake controller, part number 90885. In addition to the brake controller, we're also going to be installing the Tekonsha Tow Ready, plug-in wiring adapter for electric brake controllers for Ford F-150s, part number 22292. Now, we did not currently have a trailer hooked up to our vehicle. We'll go ahead and slide the manual override. You'll see that it reads NC for not connected. We'll go ahead and now plug in our trailer to the rear of the vehicle. Now, we can go over some functions of the brake controller. more

8/13/2014 3:36:24 PM

Universal Kit for a Trailer Brake Controller Installation - 2013 Ford F-150- Video

Today on our 2013 Ford F-150 Supercrew, we'll be installing the Universal Trailer Kit for Trailer Brake Control seven-way RV and four-way flat, part number ETBC7. The ETBC7 is a universal kit to allow you to even install a brake controller on your vehicle that already has a four-way flat mounted on it. This kit also allows you to run the 12-volt power supply back to your seven-way as well as you brake controller back to the seven-way. Now in this particular vehicle, there's already a four-way flat from the factory that we'll be tying in with. Also in this installation, we will be running all the wires for the 12-volt power as well as running a wire up for the brake controller but we'll not actually be installing the brake controller during this installation. We will show all the other connections at the rear of the vehicle as well as how we'll tie in for the 12-volt hot lead back at the seven-way. We'll begin back here at the rear of the vehicle. more

10/28/2013 4:11:15 AM