Trailer Hitch Installation - 2015 Chevrolet Silverado 2500 - Curt C15860 Video

The Draw-Tite Trailer Hitch Receiver - Custom Fit - Class V - 2-1/2" #DT45511 (no longer available) does require drilling for installation. It also requires the OEM factory bumper and brackets and allows the full size spare tire. The Curt…

When it comes to towing components like hitches, you're always going to be limited to the capacity of your lowest rated components; so adding a higher rated hitch to your vehicle isn't going to increase your towing capacity or the payload.…

The Curt Trailer Hitch Receiver - Custom Fit - Class V - 2" part #C15460 that you looked at is a replacement hitch meaning it will take the place of your current factory hitch. For a dual reciever tube opening you want to use the TorkLift…

The best option I have for a 2019 GMC Sierra 2500 WT (Work Truck) is the Curt Trailer Hitch Receiver part #C15460. The issue with the WT (Work Truck) models is that none of the aftermarket trailer hitch manufactures such as Curt or Draw-Tite offer…

The 4,400 lb tandem axles you have are supporting a very similar weight and trying to get these to support exactly the same weight consistently would be pretty tedious and not particularly beneficial. The 220 lb difference is perfectly fine so I…

Without knowing the model number it simply is not possible to tell you with absolute certainty what size receiver you have, but the largest receiver size for aftermarket hitches for a 2013 Chevy Silverado 2500 or 3500 is 2-1/2 inches, such as what is…

I reached out to my contact at Curt and it is possible that the Curt Trailer Hitch Receiver - Custom Fit - Class V Commercial Duty - 2-1/2" #C15860 will fit your 2016 GM Sierra 2500 with a Service Body as long as it did not start life as a cab…

I spoke to my contact at Curt and they informed me that the Curt Adjustable 2-Ball Mount part #C45902 uses a 3/8" hex key like the Replacement Anti-Rattle Set Screw part #C45916.

The Curt 2-1/2 inch Weight Distribution Shank part #C17131 that you referenced has 3/4 inch holes that are spaced 1-1/4 inches apart. If the head of your Eaz system is compatible with that this shank would work well for you. Nearly all WD system use…

It is not extremely uncommon for the hitch pin hole on a trailer hitch receiver to become oblong after frequent usage. This is usually attributed to frequent back and forth movement of the shank inside the receiver tube opening that in time will…

The Dexter 6K and 7K axles are very similar to each other, so it can be difficult to determine their capacity just by looks. Dexter axles typically have a specs plate near the center of the axle, but there is a chance that it could have come off. The…

The roof vents like the Fan-Tastic part #FV801208 install with a very minimal projection into the interior of the vehicle. If you check out the picture I attached you'll see that the ceiling height of your van would basically be unaffected.