Trailer Hitch Installation - 1998 Chevrolet Suburban - Curt Video

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Yes, the Curt Trailer Hitch Receiver part #C15312 is a confirmed fit for your 2007 Chevrolet Silverado 3500 Dually 4x4. The Curt Trailer Hitch Receiver is a direct bolt-on fit which means no drilling or cutting is required. If you need a trailer…

The Draw-Tite Ultra Frame Trailer Hitch Receiver #DT52MR is designed to fit with multiple style beds installed including service bodies. I have linked a set of the installation instructions below so you will be able see where the receiver installs…

The #BWHDRH25122 has 35-5/8 inches between mounting holes like what you see in the picture I attached. Since you need larger than than let me know what vehicle you have and I can see which would be best fit.

The Curt hitch part #C14029 that you referenced has been confirmed as a fit for your 1998 Chevy Tahoe and would allow you still fit your rear spare tire under the rear of your vehicle. I attached an install video for this hitch for you to check out…

Your trailer frame having an outside to outside dimension of 37 inches that means the Curt hitch part #C15325 will match up to it. The distance from the mounting surface of the hitch down to the hitch tube is going to be 4-1/4 inches. If your truck…

I reached out to my contact at Draw-Tite who was able to give me the dimensions for the Trailer Hitch #41945. He said that the #41946 is for GM frames so it won't fit your Ford E-450 Chassis. From the rearmost hole to the end of the receiver…

The Curt hitch part #C13900 that you referenced is designed to fit frame widths that range from 31 to 41 inches in width based on the holes you use. Check out the picture I attached to see how the holes match up with frame widths as well.

The Curt XD Class V Hitch #C15324 that you referenced is indeed a correct fit for your 2006 Chevrolet Avalanche. I visited our warehouse to obtain the measurements you requested. The hitch mounting flanges measure 10-11/16-inches long x 2-1/4-inches…

I can say that Curt doesn't consider the hitch a fit, but if you look at the provided photo, you can see the mounting hole spacing on the hitch and compare it to the frame member of your truck.

I'm not exactly sure between which points you want the measurement taken of the Curt hitch, part #C15324, so I took a few. On the mounting plates, outside to outside is 41 inches, inside to inside is 36-1/2 inches, and the bolt holes are 39-11/16…

According to my technical contact at Curt Manufacturing their Class V Hitch #C15302 will fit your truck, if it were equipped with a standard 265mm wide spare, with about an inch of extra space. The hitch was engineering with this tire size in mind.…