Blue Ox Base Plate Kit Installation - 2012 Jeep Wrangler Unlimited Video

Thanks for sending a picture! I went to our warehouse to measure the brackets on the Blue Ox base plate #BX1126 to provide you the measurements you are needing. The bottom edge of the bracket measures 10-inches and the top edge measures 5-1/4…

The Replacement Attachment Tab Assemblies for Blue Ox Baseplates - Short Front/Short Back, #BLU57XR comes in a quantity of 2 tabs with 2 spring pins.

The Roadmaster Base Plate Kit that fits your 2006 Mini Cooper is a part #521876-1 but from the picture you sent in it looks like you actually have the Blue Ox Base Plate Kit #BX1303 instead. If you are missing the pins then those can be found as part…

There are several components needed to flat-tow a vehicle like your 1993 Chevy Blazer. The first thing you will need is a base plate kit. For a kit that is confirmed to fit your vehicle you would want the Roadmaster Base Plate Kit #131-15. This…

Yes, a 1997 Chevy S-10 4x4 can be flat-towed behind a motorhome with all four wheels down. However, you will need to either disconnect the drive shaft each time or get a drive shaft coupling which we do not offer but I can point you in the right…

Since the etrailer base plate kit part #e98949 attaches to the bumper mount you have to drill out one of the bumper mount holes to make it large enough for the hardware of the base plate kit to fit properly.

We do offer Blue Ox base plates for the 2013 Jeep Wrangler 10th Anniversary Rubicon. I confirmed with my contact at Blue Ox that their kit #BX1134 will fit this vehicle as long as it does not have aftermarket bumpers, winches or guards. Be sure to…

To determine if you need a Roadmaster Brake-Lite Relay Kit #RM-88400 you will need to answer the following questions: Are you using a supplemental braking system that depresses the brake pedal in your towed car? No - You do not need a brake light…

Looking at the pictures of the Blue Ox base plate kit part #BX1134 installed compared to the bumper pictures you sent in of your 2016 Jeep JK Wrangler Rubicon with the Smittybilt Gen 1 bumper this base plate kit would fit.

The red wire of the Roadmaster Brake Lite Relay kit part #RM-88400 runs to a circuit on the vehicle that only sees voltage when the key is in the on position. I attached a diagram for more info as well.

To flat tow your Jeep Wrangler JK behind your motorhome, you will need a base plate kit, tow bar, safety cables, tail light wiring harness, and a supplemental braking system. Depending on the year of your Wrangler, you may also need a Brake-Lite…

If your Jeep has an aftermarket bumper installed with 15/16" holes (0.9375). The Blue Ox Aftermarket Off-Road Bumper Adapter - 7/8" Pin, #BX88357, is identified with a nominal hole diameter of 7/8". It specifically states minimum of…