Installing Brake Controller On 2005 Jeep Wrangler

Question:

with part number 5506 and part number 90885 controller you wire the blue wire from plug to controller blue wire and white and black wire from plug to under hood circuit breaker and red wire from controller at brake pedal where do you wire the controller black and white wire and could you show me a wire diagram to hard wire these products. thanks

asked by: Steve

Expert Reply:

As the enclosed drawing shows, the Black wire from the brake controller, part # 90885 should be run to the positive battery terminal and the White wire is attached to the negative battery post.

When installing the circuit breaker included with part # 5506, it will be installed in-line with the Black wire leading to the positive battery post.

I have attached a link to a helpful article that explains how to install a brake controller from scratch and another article that has helpful information about brake controllers.

expert reply by: Jeffrey L