What Size Bolt Goes on Exhaust Hanger for Installing Draw Tite Hitch # 24940 on 2012 Hyundai Sonata
Question:
The bolt holding the rear exhaust hanger fell from my installation. Please let me know what size/length bolt it is so I can replace it ASAP.
asked by: Jim R
0
Expert Reply:
The bolt that holds the exhaust hanger from the hitch part # 24965 that you referenced is a M8-1.25 x 65 mmGr. 10.9 bolt.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Where is the Dummy Plug to Install a Brake Controller Adapter on 2019 Chevrolet Silverado 1500
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Hitch for a 2024 Toyota Grand Highlander
- Q&A: How Does Trailer Hitch For 2024 Mazda CX-90 Look When Installed
- Q&A: What are the Square Tubing Dimensions of the Curt Combo Bar # E-9
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: Is Curt 2-Bike Platform Carrier Good Choice for Carrying E-Bike that Weighs 42 lbs
- Q&A: Where Does Trailer Wiring Install on a 2014-2015 Toyota Highlander
- Article: My Trailer Hitch Doesn't Fit
- Article: Rooftop Cargo Carriers
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Hitch Installation Tips
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Trailer Hitch Receiver Sizes