Coupler Recommendation for a Trailer Tongue that Measures 3-1/4 inches Wide
Question:
I have an old trailer with a 3-1/4inch tongue that I would like to put a coupler on. I can not find one anywhere. Is it even possible?
asked by: Josh S
Expert Reply:
The straight tongue couplers like the Dutton-Lainson 3-Inch Trailer Coupler, part # DL13897 are available for trailer tongues with either a 2-inch, 2-1/2-inch, or 3-inch channel. I would recommend for you to measure the trailer channel at a point where you are not measuring the coupler and see if it measures 3 inches wide. If you are measuring the width of the trailer channel including the coupler it will normally measure larger than 3 inches.
If the measurement of the trailer tongue, not including the coupler, measures no more than 3 inches wide the part # DL13897 will fit your trailer.
If you do have a 3-1/4 inch wide trailer tongue you would need to first have an adjustable channel like part # BDAC5000300 welded to the front of your trailer tongue and then use a # PSA200S0303 to bolt to the channel and provide you with a coupler.
Products Referenced in This Question
Bulldog 5-Position Adjustable Channel Bracket for Cast Head Couplers - 8" Height Adjustment
- Accessories and Parts
- Adjustable Trailer Coupler
- Lunette Ring
- Channel Bracket
- 24000 lbs
- 5 Mounting Positions
- Bulldog
more information >
Pro Series Adjustable-Channel Coupler w/ Low Latch - 2" Ball - 8,000 lbs
- Adjustable Trailer Coupler
- Coupler Only
- 8000 lbs GTW
- 2 Inch Ball Coupler
- Thumb Latch
- Pro Series
more information >