Are the 7-Way and 4-Way Next to Each Other on the Hopkins Connector HM11143395
Question:
I was told that both connectors are active, but will both the 7 way and 4 way plug fit side by side at once?
asked by: LT
0
Expert Reply:
The 7-way and the 4-way on the Hopkins Multi-Tow 7-Way Blade and 4-Way Flat Trailer Connector # HM43385 that you referenced are right next each other. If you check out the picture I attached you will see how close they are. You should have no problem fitting a 7-way and a 4-way connector next to each other.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness for Factory Tow Package - 7-Way and 4-Flat Connectors
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How To Tell If Parts Are Missing From Rear Panel Extang Solid Fold Tonneau Cover That Blew Off Truck
- Q&A: Replacing Clamps on Extang Solid Fold Tonneau Cover
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement 7-Way Trailer Connector for a 2004 Toyota Tundra with Factory Tow Package
- Q&A: Trailer Turn Signals are Reversed with Hopkins Trailer Wiring Installed on a 2006 Jeep Wrangler
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement Hub and Drum and Hydraulic Brakes for a Cronkite Tandem Axle Trailer
- Q&A: Needing to Wire a 7-Way Connector to a 2004 Toyota Tundra
- Q&A: What is the Difference Between the Towable and Non-Towable Bumper on a 2002 Toyota Tundra
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch