Pilot Brake Controller part # 80550 Flashes 00 Troubleshooting
Question:
tell me whats goning on brake controller keeps flashing 00 after unit is shut off why?
asked by: Ken
1
Helpful Expert Reply:
Your Pilot Brake Controller part # 80550 flashing 00 could be due to a few reasons.
There could be corrosion on your brake output circuit on your 7-way. Clean as necessary if so.
The power of the controller is set too low.
Or, the ground wire of the controller isn't making a good connection.
I attached an FAQ on troubleshooting brake controller installations for you to check out as well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Pro Series Pilot Trailer Brake Controller - 1 to 3 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- Digital Display
- Up to 360 Degrees
- Pro Series
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Hanger Spacing for 3500 LB. Tandem Axle Trailer
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Replacement Converter Recommendation For An American/Centurion CS6000 Converter
- Q&A: Installing Trailer Wiring on a 2014 Ford Explorer
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Q&A: Replacement For T-23973 Grease Seal on Trailer
- Q&A: How Does Brake Controller Install in 2017 Chevy Express Van
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Replace or Install an RV Roof Vent