Installing the Curt T-Connector Vehicle Wiring Harness # C56343 on 2010 Ford Flex SE
Question:
The installation instructions look straightforward, but I did not see any information about the controller unit. What/where is the suggested mounting location for the power unit on a 2010 Flex SE? This vehicle was purchased w/o the tow package. Ive installed the factory OEM hitch and looking at this Curt unit to take care of my wiring needs. Thanks for your help in this matter.
asked by: Ben
Expert Reply:
When it comes to installing the Curt T-Connector Vehicle Wiring Harness, # C56343, on your 2010 Ford Flex SE, you will adhere the powered converter box to the frame of the car in the open cavity below the driver's side taillight.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Proper Gauge Wire for Installation of a Brake Controller and Trailer Brakes
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Wire Gauge of Power Wire for the Curt Trailer Wiring Harness # C56407
- Q&A: Recommended Trailer Hitch for 2013 Ford Flex Limited with Dual Exhaust
- Article: Trailer Wiring Diagrams
- Q&A: Difference Between Wiring Harnesses for a 2009 Ford Flex
- Article: Performance Chips and Modules
- Q&A: etrailer Hitch that Fits 2018 Ford Flex with Dual Exhaust
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver
- Q&A: Weight Distribution System for 3500 GVWR Pop-Up Camper Towed by Toyota Tundra
- Article: Frequently Asked Questions About Transmission Coolers
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring