How Wide is the U-Channel of the Curt Hitch part # 13432
Question:
ON the Curt receiver for Jeeps no 13432, how wide is the inside of that U channel above the receiver tube. Would like to use on the draw bar of my tractor so I can have a receiver tube in place. My Draw Bar is 2 7/8 wide by 1 in thick. THANKS
asked by: Jerry L
0
Expert Reply:
I went and pulled a Curt Hitch part # 13432 from our warehouse and measured the inside of main channel of the hitch and found it to be 3-1/8 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Equalizer Replacement Options for Dexter 13-122 Equalizer
- Q&A: Comparing Equa-Flex and Road Armor Equalizers For 2000 Forest River WIldwood W/ 5200lb Axles
- Q&A: Can 12 Volt Battery Replace Two 6 Volt Batteries
- Q&A: Replacement Electric Brakes for Dexter PR-FF SEC-FF 5.2KPR-GGSEC-GG 12X2XQ 36-89
- Q&A: Replacement 12 inch Brake Assemblies for Dexter 36-89 on Trailer
- Q&A: Comparing Curt and Tekonsha Trailer Wiring Harness for 2018 Jeep Wrangler Unlimited
- Q&A: Recommended Tire Clearance Between Tires on Dual Axle Trailer
- Article: How to Rent an RV
- Article: What Exactly is Tongue Weight?
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: My Trailer Hitch Doesn't Fit