What Parts are Included with Hitch 24792 and What 1-7/8 Inch Ball Will Fit
Question:
I am looking at the abouve product for my 2007 Honda CRV.I need a 1-7/8 in ball for the hitch, what shank is the opening? Also I do not need to purchase a drawbar/ballmount with this hitch it comes with it? I look forward to hearing from you as I would like to purchase all of what I need from you. Thank you
asked by: Rick S
Expert Reply:
The Draw-Tite, part # 24792, is a 1-1/4 inch hitch opening. You will need draw bar part # 3593 and must only be used in the rise position on your CR-V. The draw bar has a 3/4 inch shank diameter so you could use part # 19256 as your ball. Using these parts, your maximum tongue weight is 200 pounds and maximum trailer weight is 2,000 pounds. If your CR-V has lower ratings, you must abide by those.
I have included a link to the instructions for the hitch and draw bar.
Products Referenced in This Question
1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
Draw-Tite Drawbar for 1-1/4" Hitch - 2-1/8" Rise, 2-3/4" Drop - 6-5/8" Long - 2K
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 2000 lbs GTW
- Class I
- Draw-Tite
more information >
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What if Bolt Holes Don't Line up With etrailer Hitch on 2008 Honda CR-V
- Article: How to Choose the Right Trailer Hitch Class
- Article: Best Bike Racks for Electric Bikes
- Q&A: Replacement Landing Gear Legs for Montana RV Fifth Wheel
- Q&A: How Do Tabs on Lippert LC178653 Landing Gear Leg Fit in Clips Welded onto 5th Wheel Frame
- Q&A: What Replacement Lead Leg Do I Need for My 2011 Keystone Montana Trailer?
- Q&A: Replacement Landing Gear Legs for 2009 Keystone Montana 5th Wheel Trailer
- Q&A: Difference Between Square and Round Tube Trailer Hitches for 2010 Honda CR-V
- Q&A: Hollywood Racks Destination Bike Rack Issue With Folding Up
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: What Do I Need To Tow A Trailer?
- Article: Rust Prevention
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Hitch Installation Tips