Troubleshooting a Tekonsha Voyager that is Wired Up Correctly But Wont Come On
Question:
I have the same problem as Patrick B, no LED indicator. I verified polarities to the battery, an open to the blue wire no trailer attached, and zero volts/76 ohms to the red wire brake cold side with the brake switch open. There is 12.1 volts to the red wire with the brake pedal depressed. Also turned on the blinkers for both sides to see if the voltage ped-out, stayed steady.
asked by: Richard R
Expert Reply:
It sounds like your brake controller just needs to be connected to a trailer. Try connecting it to a trailer to see if starts to work properly.
If it still doesn't work with a trailer connected, and since you tested and verified that all of the wiring connections to the controller are good the only other problem is that the controller is bad.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.
You should note that if a trailer is not connected the LED indicator will not come on.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Trailer Grease Seals for Allis 5013 29772
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Kit to Convert 2021 Vanleigh Pinecrest 335RLP to Electric Over Hydraulic Disc Brakes
- Article: Best Camper Jacks
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)