Installing Replacement Rearview Mirror On 2000 Chevrolet Impala
Question:
Will this be a simple install? Or is it more complicated than that? Thanks very much.
asked by: David S
0
Expert Reply:
When installing the 10" CIPA Rearview Mirror, part # CM32000, you will basically remove a screw, slide the old mirror up, then slide your new mirror on and replace the screw. I attached a video that explains this process.
If you need to replace the wedge mount on your windshield, I recommend the Loctite Rearview Mirror Adhesive, part # LT37438. I have attached a product review video for the adhesive you can check out.
expert reply by:
Jeffrey L
0
Products Referenced in This Question
Loctite Rearview Mirror Adhesive - Permanent - 0.01/0.02-Fl Oz Kit
- Accessories and Parts
- Rear View Mirrors
- Adhesive
- Loctite
more information >
Product Page this Question was Asked From
CIPA Rearview Mirror - Day/Night Switch - 10" Long
- Rear View Mirrors
- Flat Mirror
- Wedge Mount
- Standard View
- 10 Inch Long
- Day/Night Switch
- No Added Features
- CIPA
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: What is a Gooseneck?
- Q&A: Winch Mounting Plate Needed for Aluma 82 Series Car Hauler Trailer
- Q&A: Will a CIPA Rear-View Mirror # CM32000 Fit a 2004 Volvo C70 Convertible
- Q&A: Replacement Awning Strip Light for 2019 Keystone Cougar with 2 Solera Awnings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How to Test Brake Controller without Trailer Connected
- Q&A: How to Mount Existing 7-Way Connector on New Curt Hitch Receiver
- Q&A: Fluid Recommendation for Lippert Hydraulic Auto Leveling System
- Q&A: Tip for Removing Stuck B and W Turnoverball Hitch Ball