How Many Cranks Per Inch Does it Take to Raise the Single Speed Bulldog Landing Gear Jacks
Question:
Im trying to compare this jack to some others and Im curious how many cranks per inch this one is. The BD183816 says it is 9 revs/inch in high and 27 revs/inch in low. Obviously this jack is single speed but Im curious how many revs/inch it is for comparison sake.
asked by: Eric F
0
Expert Reply:
I spoke to my contact at Bulldog and he informed me that the Bulldog Square Jack # BD182815 that you referenced will take 9 turns to move 1 inch in either direction.
I attached a review video for this jack for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Square Jack - Drop Leg w/ Spring Return - Sidewind - 26" Lift - 10,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Alloy Steel
- 9001 - 10000 lbs
- Landing Gear
- Sidewind Jack
- 26 Inch Lift
- Weld-On
- 1 Jack
- Bulldog
more information >
Continue Researching
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Could GO Power Solar Panel kit part # 34273836 Mount to Pin Box and Use SAE Port
- Q&A: What is Max Safe Tire Temperature
- Q&A: How to Determine the Right Air Pressure to Fill a Trailer Tire
- Q&A: Bolts and Bracket for the Tie Down Caliper to Kodiak Caliper
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Hanger Spacing for 3500 LB. Tandem Axle Trailer
- Q&A: Size of Hole Saw to Use to Install the Recessed Trailer D-Ring Tie Down RR5K
- Article: What is the Best Trailer or RV Storage Cover
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings
- Article: Best Ladder Racks
- Article: Measuring a Trailer Tire