Is there a Hole to Route Trailer Wiring Harness on a 1990 Ford LTD Crown Victoria
Question:
My car has the tow package says theres a 32 mm hole by rear 1/4 panel for wires to go through,i dont see it. Have you ever worked on one of these is it possible they didnt put the hole and plug in the vehicle?
asked by: Dan B
0
Expert Reply:
We haven't had a 1990 Ford Crown Vic in to install wiring so I cannot say for sure. But it is possible that the hole in question is covered with a grommet or plug of some kind and could be difficult to see or reach. You may have to look from different angles (underneath, inside the trunk, etc) to find the hole if it is present.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Draw-Tite Max-E-Loader Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Class I Trailer Hitch for a 2021 Mercedes-Benz E-450
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Replacement Power Center For a Magnetek Model 80
- Q&A: Trailer Hitch Fit For 2019 Mercedes-Benz E-300 and E-400
- Q&A: 4-Pole Trailer Wiring Harness for 2007 Mercury Grand Marquis
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Replacement Grease Seals for Dexter Part # 010-036-00 on a 7,000lb Trailer Axle
- Q&A: Trailer Wiring Harness that Fits 2020 Mercedes GLC 300
- Q&A: Choosing The Correct 4-Way Vehicle Wiring Harness on a 2020 Mercedes Benz GLC 300
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)