Will Curt Trailer Hitch Mount Cargo Carrier 18110 Clear the Bumper on a 2008 Mazda CX-9
Question:
I mounted a 13575 receiver this weekend, and am looking for a carrier to use for travel. The receiver is fairly low to the ground, so I like that the 18110 has an angled shank. I just want to know if it will have enough clearance to not contact the back bumper on our 2008 CX-9. Thanks!
asked by: Dave
Expert Reply:
When we have installed Curt trailer hitch # 13575 on other Mazda CX-9s we found that from the center of the hitch pin hole back to clear the rear bumper measures 4-3/4 inches. On Curt cargo carrier # C18110 it measures 6-3/4 inches from the center of the pin hole to the nearest part of the carrier so there should be no interference issues. Even with the rise in the shank it should not be a problem.
You will want to measure the clearance on your CX-9 just to be safe. I have linked a help article to the right that shows how to take this measurement.
Products Referenced in This Question
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended Bike Rack For Aventon Aventure Fat Tire e Bikes
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Is Lowering the Spare Tire Needed to Install Curt Hitch on 2014 Mazda CX-9
- Q&A: Brake Controller Plug Location for 2020 Chevy Silverado 1500
- Q&A: Easy to Install Trailer Brake Controller Recommendation for 2020 Chevy Suburban
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Determining Tongue Weight Capacity of 2007 Toyota Camry
- Q&A: Replacement Bunk Brackets for Escort Boat Trailer
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Determining Trailer Tongue Weight
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: How to Install a Trailer Hitch
- Article: How Much Does a Boat and Trailer Weigh?