Parts Needed to Install a Brake Controller in a 2012 Acura ZDX
Question:
Will this harness, part # C56108, also interface with and control electric braking on a single axle trailer? Application is a 2012 Acura ZDX.
asked by: Jerry
Expert Reply:
The Curt Wiring harness part # C56108 that you referenced is needed to install and use a brake controller on your 2012 Acura ZDX, but there is one more component needed.
You will also need a part number # ETBC7. The Curt harness will control the taillights of your trailer as it is a 4-way. But to install a brake controller you will need a 7-way as well. The # ETBC7 will use the trailer lighting signals from the Curt harness and then also give you the ability to install a brake controller. Check out the install video and instructions I attached.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.
Products Referenced in This Question
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >