How to Make Trailer Wiring Harness Easier to Unplug From Trailer
Question:
The wiring harness you sent me seems to work fine, but the harness plug to my trailer plug is extremely tight. I took me 20 minutes to get it partially in to test the circuits. Is there anything I can do to make it reasonably easy? I did use contact cleaner, but it seems to be the plastic surrounding the contacts that prohibits easy installation. Thank you
asked by: Tom L
Expert Reply:
I'd recommend using some dielectric grease, like part # 11755. Not only will the grease prohibit moisture from entering the connections and protect them from corrosion, it will make the connection easier to plug together or to separate.
Products Referenced in This Question
Dielectric Grease for Electrical Connectors, 2 oz.
- Accessories and Parts
- Trailer Wiring
- Wiring
- Dielectric Grease
- LubriMatic
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Install Hardware for Draw Tite Hitch that Fits 2010 Honda Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Is The Curt Or Draw-Tite Trailer Hitch Receiver Better For a 2012 Honda Fit?
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Tire Sizing
- Article: Trailer Hitch Receiver Sizes
- Q&A: How to Determine If a 2015 Mazda CX-5 Has LED Tailights
- Q&A: How Close Does Trailer Ball Height Need to be to the Height of the Trailer Coupler
- Article: Trailer Wiring Diagrams
- Q&A: 3 Bike Rack Recommendation for 2010 Honda Fit Sport
- Q&A: Hitch and Wiring for 2009 Mazda 3 Hatchback Grand Touring
- Article: My Trailer Hitch Doesn't Fit