Would the Pro Series Round Snap-Ring Swivel Jack # PS1400300303 fit on a 2 x 2.5 inch Trailer Frame
Question:
The bolt hole pattern doesnt appear to accommodate a 2inch x 2inch tongue, but your earlier reply says it will fit a 2inch x 2.5. I am confused. Is there a better product for the 2
asked by: Andrew
0
Expert Reply:
The Pro Series Round, Snap-Ring Swivel Jack # PS1400300303 that you referenced can fit trailer frames up to 3 inches by 4 inches. Since your trailer has a 2 by 2-1/2 inch frame this jack would work for you well. The bracket would just be a little larger than needed.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pro Series Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Dimensions Of The Replacement L-Pin For Equal-i-zer 4,000 Pound WDS
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Does etrailer Bolt-On Swivel Mounting Plate Fit Jack TJP-5001S-B
- Q&A: Load Range D ST205/75R14 Trailer Tire With Galvanized Steel Wheel & 5 on 4-1/2 Bolt Pattern
- Q&A: Looking for a Bolt-On Jack That is Less Than 11 Inches When Attached
- Q&A: Will the Pro Series Round Snap-Ring Swivel Jack Bolt on a 2 Inch Trailer Tongue
- Article: How to Measure a Trailer Axle
- Q&A: Replacement Dutton-Lainson Trailer Jack 22457 or 22560
- Article: Best RV Roof Vents
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings
- Article: Trailer Jacks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)