Will Curt Weight Distribution Shanks Work with a Pro Series Round Bar Weight Distribution System

Question:

I recently purchased a Reese WD system PS49583 and need a lower shank. My receiver height to the top inside on my truck is 25inch and the measurement from the bottom of my tongue lip is 19inch roughly at level. I was wondering if shank C17122 would be a good choice in length. Thanks!

asked by: Shane W

Expert Reply:

Based on the hitch and coupler measurements you provided, you will want a weight distribution shank that will give you about 6 inches of drop. The Curt Weight Distribution Shank, # C17122, that you referenced will give you 6 inches of drop, but I recommend looking at the length of the shank. It is 16 inches long from the center of the hitch pin hole to the end of the shank.

If you do not need a shank that long, you could use part # C17121. This is basically the same shank, but it is only 14 inches long.

expert reply by: John H