Are Load Resistors Required to Prevent Hyperflashing with Putco Plasma 1156 LED Lights
Question:
Is this plug and play without the need of a resistor to avoid hyper blinking ? Thanks
asked by: Rey
0
Expert Reply:
If the bulbs you are replacing on your 2013 Hyundai Azera are incandescent then yes, you will need load resistors to prevent hyperflashing once you install the Putco Plasma 1156 LED Lights # P241156A-360.
For load resistors you would want the LED Light Bulb Load-Resistors # DI34ZR. I attached a pic that shows how they install.
expert reply by:
Jameson C
0
Products Referenced in This Question
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Putco Plasma 1156 LED Lights - 360 Degree - Amber - 2 Pack
- Vehicle Lights
- Tail Light
- Turn Signal
- Pair of Lights
- LED Light
- Replacement Bulb
- 1156
- Amber
- Putco
more information >