Compatibility of Optronics Trailer Tail Light # STL43RB With Trailer 4-1/2-Inch Opening
Question:
-Looking at the Optronics 4inch sealed round LED tail lights. I am needing to replace older, metal NON sealed lights in my travel trailer. MY raw hole size is exactly 4 1/2inch now. WILL the new LED sealed lights with rubber grommets fit into this opening? Any pointers in the install? Thanks, previous satisfied customer!
asked by: Rick
Expert Reply:
The Optronics Trailer Light # STL43RB that you referenced can mount using rubber grommet # A45GB. But this light's overall diameter is 4-5/16-inches so this light unit would be too large to allow for grommet mounting in your trailer's 4-1/2-inch opening.
However, my contact at Optronics confirmed that this mounting grommet # A45GB will fit a 4-1/2-inch rough opening and with it you can use the other light you referenced, part # STL101RB, which is 4-inches in diameter. If you need a wiring pigtail you can use # A47PB.
Products Referenced in This Question
Rubber Grommet for 4" Round Trailer Lights - PVC
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 4 Inch Diameter
- Grommet
- Round
- Optronics
more information >
Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Three Wire
- Right Angle Pigtail
- Optronics
more information >
GloLight LED Trailer Tail Light - Stop,Turn,Tail - Submersible - 21 Diodes - Round - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Shop: Optronics LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 10 Diodes - Round - Red Lens
- Q&A: Is a Gap on Either End of Cross Tube Acceptable for Draw-Tite Hitch Installation on 2023 F-150
- Shop: 5-Leaf Slipper Spring w/ Hook End for 6,000-lb Trailer Axles - 27" Long
- Shop: Rubber Grommet for 4" Round Trailer Lights - PVC
- Shop: Peterson Trailer Tail Light w/ Grommet and Plug - Stop, Turn, Tail - Incandescent - Round - Red Lens
- Shop: Gen-Y Iron Grip Anti-Rattle Hitch Pin for 3" Hitch Receivers - 5/8" Diameter
- Shop: Peterson Clearance or Side Marker Trailer Light w/ Reflector - Submersible - Round - Amber Lens
- Shop: Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Shop: Trailer Hitch
- Video: Review of etrailer Trailer Leaf Spring Suspension - 5 Leaf Slipper Spring Hook End 6K Axle - e67SR
- Video: Optronics Trailer Lights - Tail Lights - STL43RB Review
- Search Results: trailer lights
- Search Results: wiring connectors
- Search Results: wiring
- Search Results: wire
- Search Results: paint
- Search Results: reflector tape
- Search Results: break away switch
- Video: Optronics Trailer Lights - Clearance Lights - MCL48AB Review
- Q&A: What Size Hole is Required to Install Optronics Grommet A45GB
- Q&A: Does Trailer Light STL101RB Require Rubber Grommet to Install with A45SB
- Q&A: Is the Optronics LED # STL43RB the Correct Replacement for Peterson 426 Taillight
- Shop: RV Exterior Lighting
- Video: Hopkins 7-Way Molded Trailer Wire Connector Review
- Video: Optronics Rubber Grommet Review
- Q&A: 4 Inch Round Trailer Tail Light Cutout Size