Torque for U-Bolts on Trailer Axle
Question:
I am trying to install ubolts to attach leaf springs to the new axle. All the bolts are stripping at about 40 ft. lbs of torque, below specifications, and on the last 3rd set, the lock washers all sprung open and attached to the nuts. What can I do?
asked by: Mack L
0
Expert Reply:
Hey Mack, instead of cranking all the way down to the point the bolts strip just go to the point where the lock washer flattens all the way and that will work.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4" Long
- Trailer Leaf Springs
- Double Eye Springs
- 5000 lbs
- 1-3/4 Inch Wide
- 4 Leaf
- 25-1/4 Inch Long
- Painted
- etrailer
more information >
Continue Researching
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: How to Raise Your Travel Trailer Height
- Q&A: Replacement Leaf Springs and SumoSprings for 2020 Grand Design Imagine 2500RL
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Replacement, Heavier Duty 26 Inch Leaf Spring For 4,400 lb Axles
- Q&A: Replacement Leaf Spring for 2021 Grand Design Imagine 3250BH
- Q&A: What is Difference Between 6-leaf vs 4-leaf 5,000 lb Trailer Axle Leaf Springs
- Q&A: How to Increase Trailer Ground Clearance Using an Axle Over-Under Kit
- Q&A: Recommended Shocks and Equalizer Upgrade For a 2017 Grand Design Imagine 2600RB Travel Trailer
- Q&A: Replacement Leaf Spring Replacing Dexter 072-078-00 For 4,400 lb Axle