Troubleshooting Flatbed LED Lights Hyperflashing with Load Resistors Installed
Question:
I installed load resistors on my flatbed for the rear lights 6 lights in total and the lights still hyper flash even with them installed, they are installed correctly I have triple checked.
asked by: Alex M
Expert Reply:
Hey Alex, thanks for reaching out!
It could be that your load resistors aren't working properly, but I'm just wanting to check and see if you've installed a load resistor on each light, or just certain ones. It would also be helpful to know if you're referring to a flatbed trailer or a flatbed on your truck.
I really like the Load Resistor Kit for LED Turn Signals # DI34ZR and I've used it before when I needed to get an LED light on a hitch cover to work properly.
Product Page this Question was Asked From
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are Load Resistors Needed for LED Backup and Brake/Tail Lights
- Q&A: LED Tail Lights Added to Flat Bed Truck Hyper Flash with Flashers/Turn Signals On
- Q&A: Are Load Resistors Required when Adding LED Lights to a Trailer
- Q&A: Distance From Corner of Bed to Gooseneck/5th Wheel on Flatbed Truck
- Q&A: How Does Fifth Wheel Hitch Normally Install in Flat Bed Truck
- Q&A: How to Find Best Height Setting for Demco Recon Gooseneck-to-5th Wheel Recessed Ball Hitch
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: How Do I Install Load Resistors for the LED Lights on my 2007 Dodge 3500 Flatbed
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)