Recommended Disc Brake Conversion Kit for a 3,500 lbs Tandem Axle Trailer
Question:
Looking for everything for a disk brake conversion on a 2019 openrange light 2710 rl highland ridge
asked by: Larry D
Expert Reply:
To convert your 2019 Highland Ridge Open Range Ultra Lite UT2710RL to disc brakes you will need the following parts:
Kodiak Disc Brake Kit - 10" Hub/Rotor item # K2HR35D. This is for one axle so for a tandem trailer you will need to order two kits. This kit has a 5 on 4-1/2 bolt pattern and is designed for 3,500 lbs axles. It fits inner bearing item # L68149 and outer bearing item # L44649. The bearings are not included and will need to be purchased separately. The races are included but you will also need the item # RG06-050 and item # BB60002 grease seals.
Hydrastar Electric Over Hydraulic Actuator Kit for Disc Brakes - 1,600 psi item # HBA16-252-82. This includes all the lines, fittings, break away kit, and the brake actuator.
I have linked a couple of installation videos below so you can see how to get these parts set up. Our information had your Highland Ridge equipped with 3,500 lbs axles with a 5 on 4-1/2 bolt pattern if this is not correct please email me back with what capacity axles you do have and the bolt pattern so I can make the correct recommendation.
Products Referenced in This Question
Spindle Grease Seal Set for LM48548 or L68149 Inner Bearing and 1.980, 1.968 or 2.562 Bearing Buddy
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.875 Inch I.D.
- 2.560 Inch O.D.
- Bearing Buddy
more information >
Hydrastar Electric Over Hydraulic Actuator Kit for Disc Brakes - 1,600 psi
- Brake Actuator
- Electric-Hydraulic Brake Actuator
- Marine
- Travel Trailer
- Disc Brakes
- Hydrastar
more information >
Replacement Trailer Hub Bearing - L44649
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.063 Inch I.D.
- Bearing L44649
- Race L44610
- 3500 lbs Axle
- etrailer
more information >
Replacement Trailer Hub Bearing - L68149
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.378 Inch I.D.
- Bearing L68149
- Race L68111
- 3500 lbs Axle
- etrailer
more information >
Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.719 Inch I.D.
- 2.565 Inch O.D.
- etrailer
more information >
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 10" Hub/Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 3500 lbs
- Brake Assembly
- 5 on 4-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Will 3,500 lb Kodiak Disc Brake Kit Fit 2012 EZ Loader Boat Trailer
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Most Popular Wheel Bearings
- Q&A: How to Determine if Trailer has 84 Spindle to Pick Out Replacement
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: What Trailer Tire Size is Most Similar in Diameter to 7-14.5 for Trailer
- Q&A: Recommendation for Replacing Torsion Axle on Ez Loader Boat Trailer
- Q&A: Why Were The Kodiak 204 Calipers and Pads Discontinued?
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Recommendation for TDE 46210 Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)