Can You Use the Frame For a Ground for a 3,000 W inverter?
Question:
Can I attach a ground in my airstream from my 3000W inverter my drilling though the sheet metal skin into a metal structural member, tap the hole, bolt with washer and lock washer?
asked by: Steve
0
Expert Reply:
You sure can! Just make sure you're attaching the ground firmly to a clean solid piece of steel. Be sure to sand the frame to bare metal where you make your connection to ground. Then you will want to spray paint over the top of the connections to reduce corrosion to the bare steel.
expert reply by:
Jerred H
0
Product Page this Question was Asked From
LED Clearance or Side Marker Light w/ Reflector - Submersible - 4 Diode - Rectangle - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 6L x 2W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacing Peterson PM130 Incandescent Trailer Lights with LED Versions
- Article: Trailer Lighting Requirements
- Q&A: Replacement Water Heater Anode Rod For Suburban SW6D
- Q&A: LED Trailer Clearance Light Recommendation to Replace Peterson PM-130
- Q&A: What Are the DOT Requirements for License Plate Lights
- Q&A: Anti-Rattle Locking Pin VS. U-Bolt Style Anti-Rattle
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Replacing a SPB72-1621LD Pin Box with a Rota-Flex or a MORryde Pin Box with Chucking in Mind
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Wiring Diagrams
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Basics of Tie-Down Anchors
Steve H.
5/30/2024
Thanks