Width of Separation On Mounting Holes For Curt Trailer Hitch Receiver # 13040
Question:
I was wondering what the width was from the center bolt holes to each other
asked by: Todd
0
Expert Reply:
The Curt Trailer Hitch Receiver # 13040 has the mounting holes located closer to the front of the vehicle separated 40" on center. While the holes near the rear bumper are spread 39-3/4" on center. I have included an image below to help show you these measurements.
expert reply by:
Bud M
0
Mounting Hole Separation on Curt Trailer Hitch Receiver # 13040
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Is The 1/2" Metal Loom Clamp # A0500 a Single Component Or Multiple Clamps?
- Q&A: Troubleshooting Display Not Working on Touch Pad for Lippert Level Up System
- Q&A: Will the Pintle Hook # 63015 Attach to the Super Titan Pintle Hook Plate # RP38186
- Q&A: What Size Hardware Should Be Used With the Super Titan Forged Pintle Hook Plate
- Q&A: Trailer Wiring Harness for a 2013 Chevy Express Van
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Can a Leland 7921 5th Wheel Pin Box be Replaced with Gen-Y Hitch or Reese Goose Box
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Determining Trailer Tongue Weight
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch