Looking For Replacement For Idler Hub Part 94545
Question:
Looking for idler hub replacement kit for 94545. This number is on the backside of the hub.
asked by: Jamie
Expert Reply:
Hello Jamie. We definitely should have a hub that you can use as a replacement. I was not able to find any good references for the hub part number 94545 though, so I will need a bit more information from you in order to recommend a replacement.
Specifically, I will need to know the bearing sizes that your hub uses. Your best bet will be to jack up the trailer, pull one of the hubs and remove the bearings. Each bearing will have a number stamped on the edge. It appears to be a 5 lug 5 on 4-1/2" hub which is standard. It might be a standard 3.5K hub like part # AKIHUB-545-35-EZ-K but please do confirm this is what you have. If you can provide me with both the inner and outer bearing numbers I can definitely recommend a replacement. Feel free to post that info in the comments below when you have it.
Products Referenced in This Question
Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 5 on 4-1/2 - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Easy Grease
- EZ Lube
- Pre-Greased
- L68149
- L44649
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Product Page this Question was Asked From
CE Smith Trailer Idler Hub Assembly w/ Case for 2.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Pre-Greased
- Standard
- L44643
- L44643
- For 2500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 8 Inch Wheel
- 10 Inch Wheel
- 12 Inch Wheel
- CE Smith
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: How to Determine the Correct Replacement Hubs for a Boat Trailer
- Article: Most Popular Wheel Bearings
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Q&A: Lug Nut Torque Spec for Kenda Karrier S-Trail ST145/R12 Radial Tire w/ 12" Galvanized Spoke Wheel
- Q&A: Replacement Hub for a 3/4 Inch Diameter Straight Spindle
- Q&A: Recommended Replacement For An Atwood G6A-8E RV Water Heater
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Measuring a Trailer Tire
- Article: How to Bleed Your Trailer Surge Brakes