Dimensions Of The etrailer Scissor Stabilizer Jacks w/ Handle # TJSCHD-24-4 Mounting Brackets
Question:
Is there any 3D available, at least on the top plate that is being attached to the trailer? There are some dimensions like thickness or contact area that are not available.
asked by: Edgar
0
Expert Reply:
Hey Edgar,
I've attached a diagram below that should have all the measurements you need for the mounting brackets of the etrailer Scissor Stabilizer Jacks w/ Handle # TJSCHD-24-4. The brackets are about an 1/8" thick.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 10,000 lbs - Qty 4
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 9001 - 10000 lbs
- Scissor Jack
- 18-3/4 Inch Lift
- Bolt-On
- 4 Jacks
- etrailer
more information >
Continue Researching
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Install Instructions Link for Lippert Lift Kit # LC382741
- Q&A: Torque of Mounting Nuts on Lippert Torsion Axle Lift Kit
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Article: Where to Position the Trailer Axle?
- Q&A: What is the Fuse Rating and Power Wire Gauge Used for Trailer Wiring Harness # 118571
- Article: Trailer Wiring Diagrams
- Q&A: Difference Between Trailer Tire Sizes ST205/75R15 and ST225/75R15
- Q&A: Recommended Trailer Tires to Replace 225/75-14 Tires
- Q&A: Difference Between ST205/75R14 and ST215/75R14 Goodyear Trailer Tires
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Raise Your Travel Trailer Height
- Article: How to Charge RV Batteries
Edgar
5/15/2024
Thanks for the information, but I till don’t see one important dimension for me, the plates that are being attached to the trailer have some sort of bends on the sides, the dimesion I need is related to the flat area that will indeed have contact with the trailer, and the general dimension includes the bends.