What Size Are The 2 Pins On The Bauer Products Motorhome Door Lock 402-112-000 # BA64FR?
Question:
I’m looking for a door latch for my motor home. I bought one but the 2 pins are too big to fit into the latch on my motor home and that can’t be changed. Can you let me know the diameter of the 2 pins above and below the latch. I don’t know if these are the correct names for the parts, I’ll try to attach a picture. Bauer part 402-112-000
asked by: Tom M
0
Expert Reply:
The Bauer Products Motorhome Door Lock 402-112-000 # BA64FR has 1/4" diameter pins with 1/2" diameter on the ends of the pins. If this was not the pin size you needed please let me know as I did not see any pictures attached.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Bauer Products Motorhome Door Lock - Black
- RV Door Locks
- Entry Door
- Locking Latches
- Keyed Alike
- 2 Keys
- Slam Latch
- 5-1/4 Inch W x 4-1/2 Inch T
- Black
- Bauer Products
more information >
Continue Researching
- Shop: Bauer Products Motorhome Door Lock - Black
- Search Results: motorhome door lock
- Search Results: rv entry door lock
- Shop: Bauer Products Camper Door Lock - Black
- Search Results: rv door handle
- Q&A: Replacement Bauer BP-12 ETP for RV Door
- Q&A: Replacement Tack Room Door Latch For A Featherlight Trailer
- Q&A: Is The Curt C96JR Tail Light Kit Compatible With A Brake Buddy Brake System?
- Q&A: Replacing The Entry Door Latch Kit On A 2000 Featherlite Trailer
- Q&A: Replacement Latch for Bauer BP-12 of Horse Trailer
- Q&A: Is There a Replacement for a Trimark 030-0900 Door Latch
- Q&A: Recommended RV Door Latch for 5" x 5" Opening
- Article: How Does an RV Water Pump Work?
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: How to Choose the Right Trailer Hitch Class
- Article: Most Popular Wheel Bearings
- Article: Best Ladder Racks
- Article: How to Choose a Battery Charger
Tom M.
5/8/2024
Hi Bud, 1/4” diameter pins should work. The original pins were 7mm and 1/4” is 6.35 mm. I tried one that was 9mm which was too big. Thank you very much for your quick response and mailing the part. Tom