Can An Extension Cord Be Used With The NOCO GENPRO On-Board Battery Charger # NOC44FR?
Question:
NOC44FR Can an extension cord be used to power the charger? If so what are the gauge and length requirements?
asked by: Ed
0
Expert Reply:
The NOCO GENPRO On-Board Battery Charger # NOC44FR can be used with an extension cord. You must make sure you use a 3-prong extension cord. As this charger only pulls 150 watts or 1.25 amps of 120 volt power you can safely use a 100' extension cord with 14 gauge wire.
expert reply by:
Bud M
0
Product Page this Question was Asked From
NOCO GENPRO On-Board Battery Charger - AC to DC - Waterproof - 1 Bank - 12V - 10 Amp
- Battery Charger
- Battery Charger
- Boat
- Electric Vehicle
- Generator
- Trolling Motor
- 230 Ah
- Charges/Maintains
- 12V
- Wall outlet to Vehicle Battery
- NOCO
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Can 17-RPM Lift Motor for Fan-Tastic Vent B Series Be Used Instead of 7-RPM Lift Motor
- Q&A: Replacement Tray for Stromberg Carlson Trailer Tray Dimensions
- Q&A: Breakaway Switch Recommendation to Replace a Bargman Breakaway on a 1976 Nomad Trailer
- Q&A: Do Both Wires on ETBC7 Need to be Installed on 2018 Jeep Compass if Trailer Doesnt Have Brakes
- Q&A: Can Two 12 Volt Batteries Connected in Parallel be Charged Through a Switch Using a NOCO Charger
- Q&A: How To Charge 2-6v Batteries Wired In Series on Truck Bed Camper and Which Charger to Use
- Q&A: Recommended Replacement For An Atwood GCH6A-10 E S RV Water Heater
- Article: Trailer Wiring Diagrams
- Article: How to Choose a Battery Charger
- Article: Most Popular Wheel Bearings
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: 2023 Best Gifts for RVers & Campers
- Article: Flat Towing Package for 2019 Jeep Cherokee
Ed
5/5/2024
I only need approximately 20 ft of cord