What is the Width Between The Mounting Plates On The Leveling Scissor Jack # JSC-24-IND?
Question:
What is the jack dimension between the weld on mounts?
asked by: Doug G
0
Expert Reply:
The Leveling Scissor Jack # JSC-24-IND has a width of 2-1/4" between the mounting plates.
expert reply by:
Bud M
0
Product Page this Question was Asked From
Leveling Scissor Jack - 24" Lift - 5,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Steel
- 4001 - 5000 lbs
- Scissor Jack
- 24 Inch Lift
- Bolt-On
- Weld-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Correct Replacement Tire for Jingu 17.5 x 6.75 Tires
- Q&A: Rotating Flange vs Non-Rotating Lug Nuts
- Q&A: Replacement Scissor Jack for 2014 R-Pod Camper
- Q&A: Looking for Replacement Stabilizer Scissor Jack for RPod 179
- Article: How to Charge a Dump Trailer Battery
- Q&A: Boat Trailer Winch Recommendation for a 1982 Sea Ray 22-1/2 Foot Boat
- Q&A: Dimensions of Leveling Scissor Jack # JSC-24-IND
- Q&A: Where to Install Stromberg Scissor Jacks on Trailer Frame
- Article: Trailer Wiring Diagrams
- Article: Converting Your RV Water Heater to Tankless
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How Your RV Water System Works: A Complete Newbie's Guide