SnapPad Fits for a 2011 Itasca Ellipse 42QD with HWH Jacks
Question:
2011 Itasca Ellipse 42QD Front jacks appear to be 10, rear 22, HWH system. Looking for all 4
asked by: Barry J
0
Expert Reply:
Hi Barry, thanks for reaching out!
For your 10" HWH plates you can use the Replacement Pad for SnapPad Jack Stand Pad System # SP64FR but you'll need to get 2 of them since it's sold in a quantity of 1.
We don't have any pads for a 22" round plate but just in case you meant 12" plate we have the kit # SP64FR74 which comes with 2 pads for 10" plates and 2 pads for 12" plates.
expert reply by:
Jon G
0
Products Referenced in This Question
SnapPad HiWay 10 Bus Jack Pads for HWH Leveling Systems w 10" Round and 11-1/2" Round Feet
- RV Jack Pads
- 10 Inch Jack Foot
- 11-1/2 Inch Jack Foot
- 4 Jack Pads
- Round Foot
- SnapPad
more information >
Product Page this Question was Asked From
Replacement Pad for SnapPad Jack Stand Pad System - 10" Round Jack Foot
- RV Jack Pads
- 10 Inch Jack Foot
- 1 Jack Pad
- Round Foot
- SnapPad
more information >
Continue Researching
- Q&A: Heavier Duty Leaf Springs To Replace Dexter 072-097-00 On 2018 Keystone Cougar 311RES 5th Wheel
- Q&A: Electric Brake Assembly Replacements for Rockwell American 4704-L and R Assemblies
- Q&A: Replacement for Power Gear 523432 Slide Out Motor
- Q&A: How to Convert a Power Awning to a Manual Awning
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Q&A: Replacement Leveling System Control Module for 1994 Fleetwood Bounder
- Q&A: How to Determine Correct SnapPad For Winnebago Vista
- Q&A: What Snap Pads for a 2021 Newmar Newaire
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: RV Cell Boosters, How Do They Work?
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: 4-Step Guide to Installing RV Solar Power
- Article: How to Survive the Winter In Your RV
- Article: A Better Way to Find the Best Campgrounds in Each State