Trailer Jack Dimensions for the Bulldog Round Pipe Mount Swivel Jack
Question:
Bryce, regarding the Bulldog BD178101, can you please advise, 1 When it comes to trailer jacks in general, how is clearance defined? 2 what is the purpose of the clearance measurement? 3 I found the catalog for the Bulldog jacks, and it shows the clearance measurement C to be from the center of the pipe mount to the top of the outer tube of the jack. However, in some of the etrailer videos of other Bulldog jacks, etrailer is showing the clearance to be at the top of the handle very top of the jack assembly. Can you please advise whether we should consider the handle height as part of the clearance measurement, too? 4 Is a trailer Jacks retracted height, when fully retracted, the distance from the bottom of the footplate the ground to the center of the pipe mount A + the clearance C measurement? Thank you. Kelly S.
asked by: Kelly S
Expert Reply:
Hey Kelly, so clearance as we define it, is going to be the distance from the mounting bracket to the top of the jack tube excluding the handle.
Both of the extended and retracted measurements are going to be taken from the bottom of the footplate to the top of the jack tube excluding the handle. So the Bulldog # BD178101 measures 11 1/4" retracted, and 21 1/4" extended.
Product Page this Question was Asked From
Bulldog Round, Pipe-Mount Swivel Jack - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: Winch Repair Kit for Dutton-Lainson Trailer Winch Model DL1602A
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer GPS Device for Trailer Installation
- Q&A: Battery Life and Charging Time For The Linxup GPS AT3 Tracking Device
- Q&A: How Much is Monthly Service for Linxup GPS Tracking Device
- Q&A: Standard Color Code for Wiring Simple 4 Wire Trailer Lighting
- Article: Trailer Lighting Requirements
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Similar Tire Size Replacement for 7.50x16 That Is Radial Construction
- Q&A: 5,000 lb Bulldog A-Frame Jack With Short Retracted Height
- Article: How to Mount a Truck Bed Camper
- Article: How to Choose the Right Trailer Hitch Class
Kelly S.
5/6/2024
Bryce: Thank you so much. That answer to my questions was awesome. It was so easy to understand. Thank you again. Kelly S.