Is 1/4 Inch Height Difference Okay For Use With E-Z Flex Equalizers
Question:
I have a Bubbas 18foot ATV trailer with double axles. Not sure of the axle size, but its pretty beefy. The horizontal spacing on the shackle holes center to center on the equalizers is 7 3/4, but the vertical spacing between the shackle hole and the equalizer mounting hole is around 2 3/4inch center to center. I notice the K71-655-00 has the 7 3/4inch horizontal spacing, but it shows the vertical spacing as 3 inches. Is that close enough to what I have or will it not line up right being a 1/4inch different? Sam
asked by: Sam
Expert Reply:
Hi Sam,
Good question, and the mere 1/4 inch difference in the height is not going to have any type of negative effect on your trailer so you can 100 percent use the E-Z Flex Equalizers # K71-655-00.
These are a smart choice as they'll make a nice difference in how your trailer rides due to its rubber cores absorbing bounce and shock.
Products Referenced in This Question
E-Z Flex Equalizers - Double-Eye Springs - Tandem Axle - 8,000 lbs - Qty 2
- Trailer Suspension Parts
- Equalizer Upgrade Kit
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- 7-3/4 Inch Long
- Tandem Axle
- Dexter
more information >
MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps
- Trailer Suspension Parts
- Suspension Kits
- Boat Trailer
- Snowmobile Trailer
- 3-1/8 Inch Long
- Tandem Axle
- MORryde
more information >
Product Page this Question was Asked From
- Trailer Suspension Parts
- Shackle Links
- Camper
- Car Hauler
- Utility Trailer
- 3-1/2 Inch Long
- TruRyde
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Double-Eye Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Tire Sizing
- Q&A: How to Pick Out Correct Shackle Length for Trailer Suspension
- Q&A: Correct Positioning of Shackle Strap
- Q&A: Can Longer Shackle Straps be Added to Tandem Axle Trailer
- Q&A: Is There An Axle Flip Kit for a 2,000 Lb 1-3/4 Inch Diameter Axle
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Q&A: Changing Shackle Strap Length to Maximize Weight Capacity on Sagging Trailer
- Q&A: Recommended Replacement Air Conditioner For A Dometic Duo-Therm 57915.622
- Article: How to Raise Your Travel Trailer Height
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Flat Towing Package for 2005-2007 Jeep Liberty
Sam
5/4/2024
So I have all the measurements on my trailer now, just want to make sure I get the correct equalizer and shackle combination. Axle spacing is 33 1/2" Outer shackle bolt holes 7 3/4" Hanger bolt hole to shackle bolt hole is 3 7/8" Side bolt hole to hanger hole is 2 3/4" Shackle strap length is 3 1/4 So I'm a little concerned that the shackle length difference will not line up right on my trailer. Any further insight? Thanks. Sam